DAE think 'always replace the whole part' is lazy advice? My $4 fix on a dryer door switch says otherwise
I know the common advice on here is to just swap the whole assembly and not mess with it, but I don't buy that every time. Back in January I was out on a call in a little ranch house off Route 9 near Poughkeepsie, and the dryer door switch was acting up, no heat cycle unless you pressed the door in hard. The book answer was a full switch assembly at around $70 plus my time, but I pulled the switch out and found the contacts were just gunked up with lint and a little corrosion. I cleaned them with a bit of contact cleaner and a pencil eraser, bent the tab back a hair, put it together, and it worked fine, charged the homeowner $45 total and she was thrilled. Now I know some of you will say that's asking for a callback, and sure, your mileage may vary, but I've done this maybe a dozen times over the years and only had one come back. My take is we jump to replacing parts too fast because it's easier than thinking, and it costs folks money they don't need to spend. Curious if anyone else here still tries to repair the small stuff first or if I'm the last one doing it.