Pro tip: I stopped fishing cable through old walls with coat hangers after a job in Tulsa
I used to swear by a straightened wire hanger for drop lines through plaster, but on a two-story in Tulsa the hanger kept snagging on the lath and I punched through a bathroom tile. The homeowner's handyman lent me his 12 inch flex bit and a magnet puller, and I had the run done in 15 minutes with zero holes in the wrong spot. In my experience the hanger still works fine in open stud bays, but for old plaster and lathe it is just not worth the risk, your mileage may vary depending on how much you trust the wall. Has anyone else switched to flex bits for retro work, or do you still keep a hanger in the bag for quick stuff?
Switched to a flex bit last year after a hanger job went bad on me too, and it saved me the same kind of headache. I still keep a hanger in the bag for open bays where it's quick and easy, but for old plaster walls the flex bit is worth the extra setup. Less guessing means fewer surprise holes to fix later.