Ran new coax through a 1950s crawlspace in Gary and the signal got worse, not better
I snaked RG6 through about 60 feet of that low crawl under a house in Gary to get away from a nasty AC hum on the old line, and my meter showed the signal drop by 4 dBm once it was all hooked up. Turns out I zip tied the run right along a bundle of romex for most of the stretch, which I should have known better than to do. Do you reroute the whole run or just add a few inches of air gap and hope the hum goes away?
Zip tied right along a bundle of romex for most of the stretch is wild, my guy, that's like asking for trouble. RG6 picks up noise like a sponge when it runs parallel to power that long, so just adding a few inches of air gap might not cut it. Pull it off the romex and cross at 90 degrees where you have to, then check your meter again before you decide to rip the whole run out.