Hit 10,000 successful wire terminations today without a single redo

Was just going through my logbook for something else and noticed I crossed the 10k mark on my quality checks. Never thought I'd get there but I've been super careful since I messed up a D-sub pin back in 2019 that caused a 3 hour delay. What milestone numbers do you guys track in your own work?

2 comments

Log in to join the discussion

Log In

2 Comments

mason_foster682mo ago

Wait, do we count the ones we messed up too? Because I bet my redo count is a lot higher than my success count. I hit 10,000 terminations about two years ago but that's because I lose count and start over when I get distracted. Actually I'm probably closer to 8,000 on the good ones and 2,000 on the ones I pretended didn't happen until the tester caught them. But hey, at least you're honest about it, I usually just blame the wire strippers.

1

knight.taylor2mo ago

@mason_foster68 how do you hide a bad termination from the tester?

1