Watched an old timer indicate a boring bar with a cigarette paper and I thought it was a joke
Back when I ran a little Okuma lathe in a shop outside Tulsa, we had a boring bar that kept cutting about .003 taper and nobody could figure out why. I was setting indicators and fiddling with shims for two days. An old guy named Ray who had been on manuals since the 70s walked over, pulled a rolling paper out of his pocket, and stuck it between the bar and the toolholder. He said if the paper drags, you're touching, and if it slips free, you got clearance. Took him maybe 30 seconds. Turns out the holder had a burr I never saw and the paper showed where contact started. I still keep a pack of Zig Zags in my box 20 years later. Anybody else got a trick like that from an old timer that sounds dumb but actually works?